Hi there,
as some have indeed already have noticed, I'm currently not really to build so busy. But I think every now and then in the work but the leisure and relaxation, thinking up something new and to construct the then.
So I have after I've made a few thoughts how to gear effective and yet above all quieter can construct in operation. For this purpose for some time also comes the possibility of a 3D printer that operates largely independently.
So I sat down and drew a new, completely closed at the end of transmission block for my Panther tank. For this test, I have deliberately chosen one of my strong gear. Smaller and weaker variants, if it so then it works no problem.
The plastic construction I want without restrictions strength reach an audible reduction of gear noise and provide a closed design this with lifetime grease. As a small side effect of the construction cost to reduce something.
Here I have already an image of the printer simulate a gear half.
This is so still need some changes and I find it even more determined to a how I can improve the installation, but I'm going to the parts now print times and try the strength.
Greetings Edwin
