Hi ,
Recently, I 've rebuilt the RCC HL Leo on a servo driven RCC and Evolation . In addition I have created almost all parts of the 3D printer which works better than I thought have .
As more than 90 % of the necessary work consists in the parts on the PC to construct and the printer then runs automatically , I can make pretty good by the way in my local so I 'm just going to attack the next tank.
I have nich a Panzer IV turret lie with me and so now is diesern turn.
Here ever get the parts on the printer
And here a first fitting in the tower.
The design I have also adapted not only to the tower, which is much smaller , yes, but also the servo mount printed to a stop this time separately. These can then be fit to stick to the existing servos with superglue on the rocker , or just the servos directly to the edition. I 've also changed with the parts for HL- Leo . At the tower itself you must then adjust only a little.
Because I 'm doing so I'm going to do the same thing piece by piece to the other HL- tanks. For the Stug and Jagdpanther there will be two versions . With or without side straightening.
Cheers , Edwin
