Step by step you continue.
The cabinet has yet to get a little insulating material of mine for a better sound.
And so the engine then looks through the door. Here too good of a switch is then accessible.
Next, I build a micro controller of the Sol-Expert. This fits perfectly with the orginal tower drives of HL and is therefore not overwhelmed. Moreover, I need no separate power connection as well as the controller gets its power from the receiver and also the speed of Urms fits easily.
The controller I have to solder the cable, which is not easy because of the small size.
Next I do with the tower. The first is disassembled and the recoil away.
To fix the Sevos well and tarrieren the long tube at least to some extent I screw a aluminum bracket to the cradle.
Because then I glue the servos for elevation and recoil. For the flash shot I bring to a micro switch that is triggered by the retreat of the pipe. Here I examine precisely the functions with a servo tester.
Thus, the tower can be screwed again.
For the movable MG I have come up to me a very simple solution, since no precision is required for the movement. The MG is moved just over a curved 0.8 mm steel wire back and forth. By the way, I also soldered the resistors is equal to the LEDs from the MG and the headlights. Unfortunately, however, seems to have broken the driving lamp. Something just is always ....
And right now I'm in the wiring that's already relatively expensive. I will well fit even a charging cable, so you do not always have to remove for charging the tub.